Result In Zero Thickness Geometry. SectionpropertiespresectionsGeometry Constructs a rectangular hollow section centered at b2 d2 with depth d width b thickness t and outer radius r_out using n_r points to construct the inner and outer radii. Resolve Zero Thickness Geometry and Geometric Conditions Errors in Solidworks JOKO ENGINEERING - Duration.
Select which feature you are trying to make and it will tell you if your sketch is valid if not it will highlight the areas that need attention. Every edge of a solid body must have exactly two adjacent faces. Zero length geometries are not valid in the geometric network whether they apply to the geometry associated with entire network features or to the geometry associated with a section of complex edge that has mid-span connectivity.
This is observed in a helical gear tooth since the involute profile spans over a range of diameters.
The larger profile end of the loft. These discontinuities in the process are even more of a problem in newer aircraft design philosophies which use multi- delity approaches that mix higher-order analysis into the conceptual design phase to. I add-frozen a cuboid in channel and then named its side as wall. Examples of this situation include small kinks in the surface geometry with dimension of 2 x the surface thickness or less image below and zones where there are acute angle corners and thick wall constructions.